Introduction to copper detailing including laying systems, ventilation, substrates and parapet gutters.
Overview of traditional and long strip systems.
First issued in 1936, in this new edition of our long-standing busbar design guide – Copper for Busbars – the calculation of current-carrying capacity has been greatly simplified by the provision of exact formulae for some common busbar configurations and graphical methods for others.
Other sections have been updated and modified to reflect current practice. 2014. 103 pp.
This fact sheet provides technical information on the use of copper and its alloys for food contact materials, including an overview of the latest European legislation.
Yes, this is covered in Def Stan 02-833. For extruded rods and sections of size 40mm and below, an anneal at 740°C plus or minus 20° followed by air cooling is carried out. This mandatory heat treatment is to eliminate phases which are likely to give rise to selective corrosion in sea water.
- Class 1 is a forging whose failure would lead to uncontrollable flooding, the total immobilisation of the vessel or serious harm to personnel.(e.g. First Level systems in submarines).
- Class 2 is a forging whose failure would lead to severe but controllable flooding, the serious disruption of weapon systems, main propulsion machinery, or its attendant auxillaries, including generators
- Class 3 is a forging whose failure does not constitute an immediate, significant hazard.
- Class 4 is a forging which is used for forging stock only.
They can be polished to a silvery appearance.
No, the nearest alloy to Naval Brass is a leaded brass CW712R, available in rod, bar and wire. For sheet and plate the UNS Alloy C46400 (0.5 to 1.0% tin ) is used.
There is no acceptable limit – it is essential that internal stresses are removed as far as possible by a stress relief anneal at 250-350oC for 1/2 to 1 hour.
Post weld heat treatment is normally unnecessary.
This term applies to alloys such as Cu-Be and Cu-Cr which are strengthened by age (precipitation hardening). It is the temperature (900-1000C) to which the alloys are heated prior to quenching and ageing.
Yes, in the EN specification the properties are quoted separately for continuous cast (GC) and centrifugally cast (GZ) conditions.